The worldwide popular 4WD vehicles include the Jeep company. More specifically, the Jeep Wrangler is an all-around, high-end off-road vehicle. If you are a die-hard adventure lover, then you must have wanted to drive your Jeep Wrangler on steep and rough terrains. This requires some modification in the wheel section and the lift of the vehicle body.
You cannot drive on the steep roads with a factory-installed tire. Its lower diameter and the vehicle’s lower lift will cause less control over the traction and grip with the ground. That is why you need to install larger tires in your Jeep Wrangler after increasing the lift of the vehicle.
Stick to this article till the end to learn more about the compatible tire and the minimum lift required for your Jeep Wrangler.
Can you put 35-inch tires with a 2-inch lift On a Jeep Wrangler?
Yes, you can put 35 inch tires with a 2-inch lift on your Jeep Wrangler. Some minor modifications will be required to the fenders and there will be both positive and negative consequences for your vehicle and its performance on-road and off-road, but it can be done.
Advantages of 35 Inch Tire And 2 Inch Lift Upgrade
One of the common problems with Jeep Wranglers is the tire noise. It happens due to the smaller diameter of the tire and rapid wearing off.
Again driving in rough and elevated terrains also causes noise if your Jeep has a low lift. These problems can be eliminated by increasing the wheel size up to 35 inches for both axles and body height by 2 inches.
The most compatible tire size for upgrading the Jeep wrangler is 35 inches for going extreme off-roads. It improves the aesthetics of the vehicle as well as the performance on steep rocky, muddy surfaces.
Drawbacks of 35 Inch Tire And 2 Inch Lift Upgrade
You can install tires 35 inches in size in your Jeep Wrangler with 2 inches lift. By doing that, the stock fenders of your vehicle may rub with tires during every bump while driving on rough terrains.
Though it can be avoided by adding 2 inches of additional bump stop to your Jeep, again, if you are willing to go extreme off-road with your 35 inches tire, only a 2 inches lift is not sufficient.
Installing a huge 35 tire, 17 inches of the rim, and a 2 inches lift drastically increases the height of the vehicle. If you or the passengers are of short height, then it can be very difficult to get in without a rail grab.
What size tires can you put on a Jeep Wrangler with a 2-inch lift?
Jeep Wrangler can be upgraded extensively in terms of changing the wheel and tire size depending upon the lift of the vehicle.
Increasing the lift of your Jeep wrangler up to 2 inches give you the access to install tires and wheel of a higher radius.
Putting 33-inches of tire
33 inches of the tire is suitable to be installed in your Jeep Wrangler with a 2-inch lift. It will give you a better grip and torque while moving in off-road.
Besides, a 2-inches of lift gives decent wheel clearance and suspension travel while driving on rough terrains with 33 inches of the tire.
Putting 35-inches of tire
There is another option of the tires that you can add to your Jeep Wrangler with 2 inches of lift. It is the 35 inches of tire in with some additional modifications.
You have to use flat fenders to avoid friction with the new tires. The rear of the Jeep requires to be replaced to give more wheel clearance.
Finally, you have to add wheel spacers and 2 inches of aftermarket bump stop. Doing all these extra modifications, your Jeep can sustain the 25 inches of the tire with 2 inches of lift with effectiveness.
How much lift do you need for 35-inch Jeep Wrangler tires?
It is in trend to increase the wheel size of the 4WD vehicles such as Jeep Wrangler. There are two reasons people love to modify the wheel size.
These are improving the aesthetics and increasing the off-road performance. But wheel size modification on Jeep Wrangler extensively depends upon the lift of the vehicle.
There are three possible scenarios for a Jeep Wrangler to be installed with 35 inches of a tire.
No Lift Scenario
You can add 35 inches of tire in your Jeep Wrangler with no lift if the purpose is to drive on-road only. But it is not recommended at all. This will potentially damage your vehicle while driving slightly off-road.
Besides, you need to remove the fenders completely, add wheel spacers and also add wheel flairs to make it work. Doing all these modifications costs a lot and is not worth it.
Two Inches Lift
An increment of 1.5-2 inches of lift would be a decent minimum lift for your Jeep Wrangler with 35 inches of the tire.
You can use the 2 inches Mopar lift kit to increase the lift of your vehicle. Moreover, there are various other companies that can provide you with quality lift kits for your Jeep Wrangler.
Adding More Than 2 Inches Lift
To ensure better performance and safety of your fenders and to avoid rubs, you have to add increased lifts to your vehicle.
It is better to make an increment of 3-4 inches of lift with 35 inches of the tire. This should be done if you are an extreme off-road driving enthusiast.
It can be done in two possible ways. Either you have to install the suspension lift kits of different brands such as Mopar, Teraflex, etc., or add the body lift kits.
Conclusion
Owning a Jeep Wrangler is very exciting for the ultimate off-road driving enthusiast. If you are one of them, then you may have considered installing after the market 35 inches of the tire.
For such a modified setup, you may also require to increase the lift of the vehicle to get more clearance. You may wonder if your Jeep Wrangler with 35” tire and 2” lift is an overall good combo.
It is a doable combination that can give you a moderate experience of off-roading after you make some minor changes in the body kit and suspension.
Related Posts:
